Name two devices can interfere with the operation of a
wireless network because they operate on similar frequencies?
What are three basic parameters to configure on a wireless
access point?
What is the maximum data rate specified for IEEE 802.11b
WLANs?
Which encryption type does WPA2 uses ?
When two laptops directly directed wirelessly,what type of
topology has been created ?
Which Spread spectrum technology does the 802.11b standard
define for operation ?
Which two wireless encryption method are based on RC4
encryption algorithm ?
Which is the minimum parameter need on the access point inorder
to allow a wireless client to operate on it ?
What is the frequency range of the IEEE 802.11g standard?
What is the maximum data rate for the 802.11a standard?
What is the maximum data rate for the 802.11g standard?
Can access point enabled with LWAPP, join the controller
enabled with CAPWAP?
Give an example of access point model, which can join only
CAPWAP & one example which can join either of LWAPP or CAPWAP?
When access point starts up, what will be the behavior in
regards of LWAPP & CAPWAP?
What are the basic guidelines for implementing CAPWAP?
How to use USB console port on the Cisco 5500 wireless?
How WLC works in terms of packet transfer or what is the
mechanism?
What is the master controller mode on WLC?
What is the function of WLAN on WLC?
How does DHCP work with the WLC?
How do i change power & channels for a LAP?
What happens to the wireless network when I perform a
software upgrade? Do all the access points (APs) registered to a WLC go down
until they are upgraded, or are they upgraded one at a time so that the wireless
network can remain up?
Can a Cisco IOS Software−based access point (AP) that has
been converted to lightweight mode register with Cisco 4100 Series WLCs?
Is it possible to go back and make corrections in the WLC
configuration wizard at the time of the initial configuration?
With the “ Management via Wireless” feature enabled on WLCs
in a mobility group, I can only access one WLC from that mobility group, but
not all. Why?
Is it possible to assign an integrated controller in a 3750
Switch and a 4400 wireless LAN controller within the same mobility group?
Are there any basic requirements to maintain when I use the
mobility anchor feature in order to configure wireless LAN controllers (WLCs)
for guest access?
If the WLCs in the same mobility group are separated by
Network Address Translation (NAT) boundaries, can they communicate mobility
messages with each other?
Can we place the lightweight access point (LAP) under Network
Address Translation (NAT)?
Does LWAPP from access point (AP) to WLC work through NAT
boundaries?
Can I upgrade the WLC from one major version to another
directly?
How do I prevent loops on the WLC?
Is there any way to recover my password for WLC?
Why are our access points (APs) that are registered to other
WLCs that are in the same RF group shown as rogues?
0 Comments